There is a special feature called ‘Deep Coat’ that can allow Cygnus gauges to measure metal thickness through up to 20 mm of coating. Please contact Cygnus for details of how this feature can be enabled on certain gauges. Please note however the ability to measure through thick coatings depends entirely on the type of coating, we can not guarantee the gauge will measure through every type of coating.
Only Cygnus probes should be used with Cygnus gauges. The specifications of Cygnus probes is carefully controlled to ensure optimum performance from your Cygnus gauge. Using non-Cygnus probes may cause incorrect or unsatisfactory operation.
Yes. Although the majority of applications require the gauges to be used on steel, the gauges can be used on a variety of other materials by either entering the known velocity of sound into the gauge in metres per second, or by calibrating the gauge with a known thickness of the material under test. Typical examples include, aluminium, copper, grey cast iron, magnesium, nickel, mild steel, tool steel, stainless steel, tungsten, monel, inconel, phosphor bronze and brass.
Yes, otherwise an incorrect reading will be shown. For the Velocity Table click here. These are also listed in the manual supplied with the gauge.
If only a few measurements are to be taken on a material other than Steel, it may be easier to leave the calibration set for Steel and convert the readings by multiplying by the Conversion Factor for the material being measured:
True Reading = Reading x Conversion Factor
Conversion factors are listed in the Velocity Table. This method avoids unnecessary re-calibration.
All Cygnus gauges are calibrated for Steel when they are manufactured and the calibration can be adjusted to suit the type of material under test. Certificates of calibration are issued at the factory. The gauges can be returned for recalibration at the customer’s request and in accordance with their own quality requirements. This is usually every 12 months when the equipment can be tested, checked and recalibrated using equipment traceable to national standards.”
The European Standard BS EN 15317 ‘Characterization and verification of ultrasonic thickness measuring equipment’ recommends all gauges to be subject to an annual Performance Check to ensure correct operation. All new Cygnus gauges are manufactured in accordance with this standard.
Assuming the batteries are good the next thing to check is if the Probe Membrane is fitted correctly, has enough couplant behind it and is not damaged or worn. There are instruction on Probe Membrane care on the Technical Downloads page.
Gain Settings. Some Cygnus gauges have a Gain Setting in their menu:
To correctly set the Gain follow these simple steps:
Yes, the Cyglink application will work with all versions of Windows (2000, XP, Vista, 7, both 32 & 64 Bit versions).
However, the serial to USB converter may require the latest driver installing. You can download the latest drivers for the USB to Serial Converters from Technical Downloads in the File Downloads section. You will just need to register your details to access it.
The small grey USB to Serial Port Cable
The Black USB-485 Converter from KK Systems
The company has BS EN ISO 9001:2000 certification for the design, development, manufacture and repair of ultrasonic measuring equipment and associated accessories.
Cygnus recommends Duracell Procell batteries for all gauges that require disposable batteries.
That will depend on your requirements. The operation of the Cygnus Instruments range of products is straightforward. Measurements can be taken by a competent operator with minimal training. If however you need to provide certified readings then you may need to have specific training to comply with your customers requirements.
Please wait while you are redirected to the right page...